W3cubDocs

/Web APIs

RTCOutboundRtpStreamStats: pliCount property

The pliCount property of the RTCOutboundRtpStreamStats dictionary states the number of times the remote peer's RTCRtpReceiver sent a Picture Loss Indication (PLI) packet to the RTCRtpSender for which this object provides statistics.

A PLI packet indicates that some amount of encoded video data has been lost for one or more frames.

Value

An integer value indicating the number of times a PLI packet was sent to this sender by the remote peer's RTCRtpReceiver. These are sent by the receiver's decoder to notify the sender's encoder that an undefined amount of coded video data, which may span frame boundaries, has been lost.

Note: This property is only used for video streams.

Usage notes

Upon receiving a PLI packet, the sender may have responded by sending a full frame to the remote peer to allow it to re-synchronize with the media. However, the primary purpose of a PLI packet is to allow the RTCRtpSender for which this RTCOutboundRtpStreamStats object provides statistics to consider techniques to mitigate network performance issues. This is often achieved by methods such as increasing the compression or lowering resolution, although the mechanisms available to reduce the bit rate of the stream vary from codec to codec.

Specifications

No specification found

No specification data found for api.RTCOutboundRtpStreamStats.pliCount.
Check for problems with this page or contribute a missing spec_url to mdn/browser-compat-data. Also make sure the specification is included in w3c/browser-specs.

Browser compatibility

See also

  • RFC 4585, section 6.3.1: Definition of "PLI messages" in the document Extended RTP Profile for Real-time Transport Control Protocol (RTCP)-Based Feedback (RTP/AVPF).

© 2005–2023 MDN contributors.
Licensed under the Creative Commons Attribution-ShareAlike License v2.5 or later.
https://developer.mozilla.org/en-US/docs/Web/API/RTCOutboundRtpStreamStats/pliCount