W3cubDocs

/MariaDB

ITERATE

Syntax

ITERATE label

ITERATE can appear only within LOOP, REPEAT, and WHILE statements. ITERATE means "do the loop again", and uses the statement's label to determine which statements to repeat. The label must be in the same stored program, not in a caller procedure.

If you try to use ITERATE with a non-existing label, or if the label is associated to a construct which is not a loop, the following error will be produced:

ERROR 1308 (42000): ITERATE with no matching label: <label_name>

Below is an example of how ITERATE might be used:

CREATE PROCEDURE doiterate(p1 INT)
BEGIN
  label1: LOOP
    SET p1 = p1 + 1;
    IF p1 < 10 THEN ITERATE label1; END IF;
    LEAVE label1;
  END LOOP label1;
  SET @x = p1;
END

See Also

  • LEAVE - Exits a loop (or any labeled code block)
Content reproduced on this site is the property of its respective owners, and this content is not reviewed in advance by MariaDB. The views, information and opinions expressed by this content do not necessarily represent those of MariaDB or any other party.

© 2019 MariaDB
Licensed under the Creative Commons Attribution 3.0 Unported License and the GNU Free Documentation License.
https://mariadb.com/kb/en/iterate/